Rooks Metal grinding wheel 125x1.0x22.2 - T41

ROOKS cutting and grinding discs are characterized by an excellent mixture and ratio of corundum grains, synthetic resin binder and reinforcing cross fibers.

The discs comply with international standards and safety requirements for bonded abrasives EN12413. The content of harmful chemical compounds is below 0.1%. Therefore it meets health-safety requirements and environmental requirements.

The grinding wheel type is AWA60QBF41 A - the abrasive grit type used in the wheel is electrocorundum with medium granulation 60. Hardness Q which means a hard drive.

1. Grinding wheel type 41: Max. (safe) speed 12200 rpm. Allowed linear speed 80 m/s
2. Grit size: A60 and is intended for cutting steel and stainless steel.
3. The attachment: T41 and a hole of 22.2 mm allows working on almost any hand grinder at a right angle.