Looking for a timing belt for your car? Order now

Worn timing belt

A timing belt can last between 60,000 and 120,000 km, depending on the type of engine. As you can see, this is a spacious cute, so it's important to inspect the belt regularly and replace it in time. Of course, the belt can also fail earlier. A timing belt needs to be replaced if it is outdated, dried out or cracked. These symptoms can cause the belt to break.

A worn timing belt can be recognized by a number of points. First of all, it is important to perform a visual inspection on a regular basis. During this inspection, do you see any cracks, dents or shreds in the belt or does the belt seem stretched? Then the timing belt definitely needs to be replaced. In addition to seeing a worn belt, you can sometimes hear it. When the belt is stretched, it will sometimes slip while driving and cause a dragging noise. Do you hear this regularly? Then take a look under the hood. It is absolutely not recommended to continue driving with a worn belt. A worn timing belt can snap. If it snaps while driving, there is a good chance that the entire engine will jam. And this can lead to very high costs.

Replace timing belt

If inspection shows that the belt is worn, it will have to be replaced. When you replace the timing belt, we recommend that you replace the water pump immediately. The water pump wears proportionally to the belt. Replacing them at the same time will save you money and time in the future. You can replace a timing belt yourself if you have some technical knowledge. Replacing it yourself will save a lot of money. Replacing a timing belt at a garage can be between € 800 and € 1000. In short it works like this:

Rotate the crankshaft so that it is aligned with the engine block;

Remove all parts around the belt for better access;

Now loosen the tensioner adjusting screws;

Now loosen the belt. Now you can also unscrew and replace the water pump directly. Remove the old gasket residue with a gasket remover.

Now you can put on the new belt. Pay close attention to the markings. The crankshaft marking should point to top dead center. The marking of the camshaft is on the same line as that of the block itself and can often also be recognized by a top dead center marking.

Then set the tensioners correctly and turn the crankshaft twice so that the belt runs taut along the tensioner;

Check that all markings are correct. Then reassemble all parts as before.

Buy timing belt

Buying a timing belt or timing set is quick and easy at Winparts. Timing belts are available from various top brands such as Contitech, Gates, Blue Print and FEBI. In addition to individual timing belts, you can also buy complete timing belt kits from us. A timing kit often consists of a belt, tensioner and water pump.

Timing belt

A timing belt is a toothed belt that is made of a strong plastic. This part can be found between the crankshaft and the camshaft, the belt provides the connection between these two parts. As soon as you start the car, the crankshaft will turn. The timing belt then ensures that the camshaft also starts to rotate, which then regulates the position of the inlet and outlet valves. Together they provide a running engine. If the timing belt is defective, the car will not run. It is important to replace it in time! You can choose only a belt or a complete distribution kit including water pump and tensioner. Some cars have a timing chain instead of a belt.

8121 - 8140 / 8156 Products

Filter

0 filters selected

Block view
List view

timing belt 81926847 Swag

Number of Teeth: 97
Application: Timing Belt
Distribution Set: Without water pump
Material: HNBR (hydrogenated nitrile butadiene rubber)
Surface: PTFE coating (polytetrafluoroethylene)
Observe service information
Belts: With rounded tooth profile
Warranty: 2 years
Width [mm]: 25