Jumper cables - Buy Reliable Car Battery Boosters Now

Which jumper cables

We defintely recommend to have a set of jumper cables in your car. Whenever you have a dead car battery, you will be able to start the car again. When you start using jumper cables to start your car, make sure you use the correct jumper cables and connect them correctly. Heavier engines (diesels) with a high starting current require thicker starter cables (25 mm). Lighter motors require approximately 15mm cables.

Use jumper cables

To use and connect jumper cables, you can follow the steps below:

- Connect the red clamp to the positive terminal (+) of the assisting car's battery;

- Connect the remaining red clamp to the positive terminal (+) on the battery of your car;

- Then connect one black / blue clamp to the negative terminal (-) of the assisting car;

- The other black/blue clamp must be placed on bare metal in the car with the dead battery;

- The assisting car then turns on the engine, run it for at least 5 minutes;

- Try to start the engine of the car with the dead battery, but do not immediately disconnect the cables, leave it for a while.Did the car start? Let it run for about 5 minutes. This gives the car battery the time to charge;

- Then, while both cars are still running, remove the jumper cables properly. The battery of the requesting car will not yet be sufficiently charged to be able to start under its own power so keep it running.

- After you have removed the cables correctly, you will have to drive the car for a while to charge the battery properly. Otherwise, the car will not start again the next time.

Buy jumper cables

You can buy a set of jumper cables quickly and easily at Winparts. You can choose from specifications such as cable thickness, cable length, starting power and material. At Winparts you can also find other tools and car parts such as battery chargers, battery boosters, spark plugs, alternators and starter motors.

Jump leads

If the car will not start and the car battery is empty, you can use jumper cables to start the car again. To be able to use jumper cables, you need an assistance car, as you use the car battery of the assistance car to charge the one of the needing car. However, it is important that you use the right jumper cables. Heavier engines (diesels) with a high starting current require thicker starter cables (25 mm). Lighter motors require approximately 15mm cables. You can order jump cables quickly and easily at Winparts.

21 - 34 / 34 Products

Filter

0 filters selected

Block view
List view

Osram BATTERYstart Jumper cables 300A

5 1 review

Osram BATTERYstart Jumper cables 300A

5 1 review

Clips: Copper
Cable thickness: 16mm²
Taxability: 300A
Peak Current [A]: 300
Length incl. plug [cm]: 300
Warranty: 2 years
Section [mm²]: 16
Short-circuit protection: Yes