Steering wheel control interface
Retain the original steering wheel remote control functions,
if you trade in your factory radio for an aftermarket radio.
Compare the adapter's illustrated connector with
the one in your car to make sure you have the right one.
Also check if any of the
specified original factory radio is installed in your vehicle!
Remark:
CAN bus
Connection: 20-pin Land Rover connector
Connection: OEM steering wheel remote control > 3.5mm jack / loose cable
Connection: OEM sound system MOST > Cinch(m) red/white
Connection: fiber optic loop(f) MOST ring > OEM display
Vehicles with OEM MOST sound system
Vehicles without Alpine OEM Touch Screen
Vehicle settings not supported
Date/time settings not supported
Fader function not supported:
Cinch(m) > front preamp output aftermarket radio
DIP switch settings for the retrofit device manufacturer (see BDA)
Suitable for the following vehicles:
Land Rover Range Rover (LM/Vogue) 09/2009 - 12/2012
The following signals are provided:
Vehicles that are re-imported or vehicles with different software may be functionally incompatible.
red: +12V ignition terminal 15
orange: +12V lighting terminal 58
purple/white: +12V reversing signal
pink: speed signal
green: ground GND handbrake signal
Output load capacity: 250 mA max.
Current requirement greater than 250 mA:
1 relay Coil resistance 75 Ohm min.
2 relays Coil resistance 150 Ohm min.
Steering wheel remote control
OEM Sound System > Fader function not supported
Suitable for: Land Rover Range Rover 2009-2012