Discover Brake Caliper Rebuild Kits at Winparts

When to rebuild caliper

Revision of the brake calipers is recommended every three years or after approximately 75,000 kilometers of driving. Sometimes early brake caliper revision is necessary, which can be recognized by a number of symptoms. The first symptom is a squeaking noise when braking. A squeaking noise during braking can indicate that there is rust. This will cause the brake calipers to slowly get stuck. This can also ensure that the car comes to a standstill much less quickly. Another symptom is running out of brake fluid quickly. This can indicate that a brake caliper is leaking. A leaking brake caliper can also be fixed with a brake caliper rebuild.

Rebuild brake calipers

Revising the brake caliper is a relatively easy job and you can easily do it yourself. The brake calipers can be rebuilded using the following steps.

1. Remove the brake caliper. Once the brake caliper has been disassembled, place it in a vice and then remove the larger, coarse dirt with a wire brush.

2. Thoroughly clean the brake caliper, piston and guide bushes with sandpaper and brake cleaner. Do you discover holes in the piston? Then you should also replace it.

3. Coat the parts with brake paste.

4. Install the new parts from the rebuild kit.

5. You can now also reassemble the piston and fit a new rubber in the guide bush.

6. Put the brake caliper back in place.

7. Bleed the brake cylinders until no more air comes out and retighten the drain plug.

Buy Brake Caliper Revision

You can easily find the right brake caliper rebuild set for your vehicle with your license plate or car model. You can easily enter these on the website, the suitable car parts will then be displayed. Are you looking for other brake parts such as brake discs, brake pads, brake drums, brake lines or brake calipers? These can also be found in our wide range!

Brake caliper rebuild

When the brake calipers need to be replaced, a brake caliper rebuild can offer a solution. rebuilding calipers is generally a lot cheaper than buying new ones. Caliper rebuild kits help restore brake quality, remove rust and prevent brake fluid leakage. By rebuilding the brake calipers every three years, the braking power remains optimal and leaks can be detected at an early stage. At Winparts you will find brake caliper rebuild sets from top brands such as ABS, Bosch and ATE. Enter your license plate or select the car model on the website. The correct car parts will then be displayed.

6481 - 6500 / 6501 Products

Filter

0 filters selected

Block view
List view

Screw, suspension

Fitting Position: Front axle, left and right
Warranty: 2 years
Fitting Position: Rear
Fitting Position: Front
Fitting Position: Upper
Supplementary Article/Info 2: With front window
Supplementary Article/Info 2: With nut
Required quantity: 1
Steering arm type: For triangular support arm (BW)
Weight [kg]: 1
Number of parts [-piece]: 4